top of page

Department Of Electrical Engineering

134243.webp
Projects
1.Underground Cable Fault Locator Using GSM Modem:

This Project is intended to detect the location of fault in underground cable lines from the
base station to exact location in km using a PIC Microcontroller (PIC18f458). It detects the fault
and send SMS to mobile.

IMG_9510.jpg
Submited By:
Kandi Ruthvija
IMG_9502.jpg
Mugdha Taklikar
IMG_9503.jpg
Nikita Salve
IMG_9504.jpg
Pooja Walse
2. Smart Solar Monitoring and Cleaning System:

As technology is advancing, cost of renewable Energy equipment is decreasing which has resulted in a massive increase in solar photovoltaic installations. Most of These installations act as auxiliary power source. A majority of These are installed in
inaccessible locations – as close as a Rooftop to as far away as a dessert.

IMG_9509.jpg
IMG_9511.jpg
Submited By:
IMG_9505.jpg
Vishal Gujare
IMG_9506.jpg
Mahesh Tiwaskar 
IMG_9507.jpg
Ganesh Halnar 
IMG_9508.jpg
Pratik Kambale
3. SOLAR BASED SMART WATER SPRINKLER SYSTEM

The world's most serious socioeconomic issue is a lack of water resources, notably in agriculture, where vast volumes of water are needed. Farmers struggle to maintain their fields during water shortages, resulting in either overwatering or underwatering which can harm the plants. To address this, we created a solar-based smart water sprinkler system that considers different aspects of gardening and landscaping and ensures plants receive the correct amount of water.

imm1.jpg
Submited By:
aa.png
Nikhil Kalsait.
ab.png
Omkar Kundle
acca.png
Shivpal Karne.
accd.png
Hrishikesh Sanap
4. Fuzzy Logic Based Maximum Power Point Tracking Algorithm For             Photovoltaic System

Photovoltaic (PV) systems have gained significant popularity as a clean and sustainable source of energy. In our project introduces a novel approach to maximize the power output of a photovoltaic (PV) system through fuzzy logic control (FLC) for maximum power point tracking (MPPT). MPPT is essential in PV systems to optimize solar energy utilization by continuously adjusting the PV module's operating point to its maximum power point (MPP) under varying environmental conditions.

vd.jpg
Submited By:
cd1.png
Sakshi Gaikwad
cd2.png
Shubham Kale
cd3.png
Sakshi Kolhe
cd4.png
Devanand Kamble
bottom of page